obniz Quickstart (obnizOS 2.1.1 or earlier)

Step1. Start obniz Board

Power supply is required from mobile battery or PC.
Turn on the obniz Board by plugging in a USB.

To shutdown, just unplug the cable.

Attention

When the startup screen is displayed as a below, obniz Board is an new version of OS.

Please refer Quickstart for obniz Board (obnizOS 3.0.0 or later), because the display is different.

Step2. Connect Wi-Fi

obniz Board will show a Wi-Fi SSID list on its OLED. Choose one by moving the switch towards left or right, and confirm selection by pressing the switch.

The cursor is moved when turn the dial switch.Click the dial switch to selest.

Enter password

Type the password one by one by using the dial switch.

When you mistyped, choose [BACK] to delete one character. When you finish, choose [END] to connect.

You can also set Wi-Fi connection using a smartphone or PC browser. See below:Wi-Fi(Document)

QR code will appear on its OLED when successfully connected to Wi-Fi and obniz Cloud.
The 8-digit number displayed is the obnizID.

If an error is displayed or startup is not possible → See Troubleshooting.

Step3. Run the program

Please read the QR code displayed on the obniz Board with your smartphone. The program editor will open.

Using PC

Please open the Program editor. When prompted for obnizID, please enter your obnizID (the 8-digit number displayed on your obniz Board).

Tap (click) [Run] at the top right of the screen to open the run screen and run the program.

In the initial state, character input and LED ON / OFF buttons are displayed and can run programs.

The program ends by closing the execution screen.